jaspendlove
01-06-2009, 09:30 PM
For this you will need
10mm Socket to remove Plenum
A piece of 5/8 power steering hose to supplement the piece of hose you already get. You also need hose clamps.
Flat head screwdriver
http://img179.imageshack.us/img179/1112/jdmblingkb9.jpg
Remove the engine cover by removing these four screws. The ones in the back are a pain, but if you use a 10mm combo wrench you will be able to get it under the strut.
http://img224.imageshack.us/img224/6344/plenumvy1.jpg
Set the engine cover and the screws aside.
Remove the hose that connects the PCV to the lower collector (circled in red)
I found the clips to be quite the pain, however if you just pull hard enough on the hose, it comes off.
http://img245.imageshack.us/img245/9641/pvcplenumsb7.jpg
Set that hose aside.
From here plug the two hoses into the catch can and mount it where you would like. I mounted mine to the head shield around my pop charger.
http://img148.imageshack.us/img148/8920/img5245br6.jpg
I then ran the hoses under the piece of plastic in front of the car. I drilled two small holes so I could just zip tie it under that plastic piece.
Start the car, check for any whistling noises - put the engine cover back on and enjoy!
direct link
http://my350z.com/forum/engine-drivetra ... stall.html (http://my350z.com/forum/engine-drivetrain-and-forced-induction-diy/231134-diy-cusco-oil-catch-tank-install.html)
10mm Socket to remove Plenum
A piece of 5/8 power steering hose to supplement the piece of hose you already get. You also need hose clamps.
Flat head screwdriver
http://img179.imageshack.us/img179/1112/jdmblingkb9.jpg
Remove the engine cover by removing these four screws. The ones in the back are a pain, but if you use a 10mm combo wrench you will be able to get it under the strut.
http://img224.imageshack.us/img224/6344/plenumvy1.jpg
Set the engine cover and the screws aside.
Remove the hose that connects the PCV to the lower collector (circled in red)
I found the clips to be quite the pain, however if you just pull hard enough on the hose, it comes off.
http://img245.imageshack.us/img245/9641/pvcplenumsb7.jpg
Set that hose aside.
From here plug the two hoses into the catch can and mount it where you would like. I mounted mine to the head shield around my pop charger.
http://img148.imageshack.us/img148/8920/img5245br6.jpg
I then ran the hoses under the piece of plastic in front of the car. I drilled two small holes so I could just zip tie it under that plastic piece.
Start the car, check for any whistling noises - put the engine cover back on and enjoy!
direct link
http://my350z.com/forum/engine-drivetra ... stall.html (http://my350z.com/forum/engine-drivetrain-and-forced-induction-diy/231134-diy-cusco-oil-catch-tank-install.html)